Adjustable case / stand for a Lilygo T-Display S3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adjustable case / stand for a Lilygo T-Display S3
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 144
- Makes
- 0
- Views
- 1,703
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This model is sized for the Lilygo T-Display S3-display, not the Lilygo T-Display-S3 AMOLED device which is slightly narrower. If you're interested in the model for the AMOLED device it is available here.
Required:
- a Lilygo T-Display-S3 ( No Soldering Pin version)
- a USB C cable
- a couple of Dupont wires (20 cm or longer) (red and black would be good)
- a usb female jack connector
- either electrical tape + optionally polyolefin Heat Shrink
- wire cutter / stripper
- soldering iron, solder
To assemble please follow the instructions shown at the link for the original model for the AMOLED device.
An important note: once assembled, removing the ESP32 from the case to update its software and then putting it back in will be much harder then doing an Over The Air (OTA) update. Accordingly, if you're using this model for a project where you feel the ESP32's software may need to change in the future then it would be best to ensure that the software supports OTA updates.
If this model will be helpful to you, please like it here on Printables.com