1 / 11
TwoTrees Sapphire/Sappheiros Pro/Plus/SP-3/SP-5 Hotend Rear Cover
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 33
- Makes
- 0
- Views
- 771
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support on top for those wires.Do NOT forget to install the spacer, this cover will prevent your Y axis from homing because the rear cover will prevent your printer from touching the limit switch
You will need to buy the following screws:
Materials
- 2x M4x8 (to attach spacer)
- 2x M2x4 (to attach rear cover to top piece)
- 4x M3x4 (for wire harness bracket)
Install Steps
- Install spacer first
- Install top piece
- Remove the 4 rear screws from the fans and the top 2 screws that hold the hotend onto the carriage
- Screw those screws into the rear cover
- Place the rear cover in-place and tighten screws
- Place caps over the holes on the rear cover, and attach the rear bracket onto the wire harness
Print Settings
Printer:
Sapphire Plus
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
25%
Filament:
Polymaker Polyflex PLABlack
Category: 3D Printer Parts