1 / 11
TwoTrees Sapphire/Sappheiros Pro/Plus/SP-3/SP-5 Hotend Rear Cover
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 769
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support on top for those wires.Do NOT forget to install the spacer, this cover will prevent your Y axis from homing because the rear cover will prevent your printer from touching the limit switch
You will need to buy the following screws:
Materials
- 2x M4x8 (to attach spacer)
- 2x M2x4 (to attach rear cover to top piece)
- 4x M3x4 (for wire harness bracket)
Install Steps
- Install spacer first
- Install top piece
- Remove the 4 rear screws from the fans and the top 2 screws that hold the hotend onto the carriage
- Screw those screws into the rear cover
- Place the rear cover in-place and tighten screws
- Place caps over the holes on the rear cover, and attach the rear bracket onto the wire harness
Print Settings
Printer:
Sapphire Plus
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
25%
Filament:
Polymaker Polyflex PLABlack
Category: 3D Printer Parts