Splint for broken Küschall K Series Wheelchair Frame / Footrest Assembly
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stopgap part to stabilize the wheelchair until replacement parts arrive
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 16
- Makes
- 1
- Views
- 485
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
We designed this part to stabilize the broken frame pipe, which broke right above the welding line which secured the castor wheels (see photo). The assembly is holding the footrest pipe and the frame pipe together, so weight and tension can be applied on the footrest on a Küschall K Series Wheelchair (the version with round pipes). The original part had broken, which means that the footrest was coming loose on one side of the wheelchair. Since the expected time to repair was several days at best, months at worst, we decided to design and print a part to assist in holding the wheelchair together.
We are sharing this part not because it will be immediately useful to many people, but to show a possible starting point for your own designs. If you want to build upon it, you can find the editable design on OnShape. Most of the parts are parameterized, so it should be relatively straightforward to adjust to your own wheelchair, assuming it has round parts.
To assemble, you will need two pipe clamps that fit around the top and bottom ring of the assembly. You should be able to find these in any hardware store. Use the type that has a screw to tighten it. In the CAD file, there is also a partially finished alternative design that can be held together with screws - we abandoned the design after getting the idea with the pipe clamps, but used an earlier prototype that was held together with screws, which worked very well for several days before we replaced it with the clamp version.
We further stabilized the whole thing by running a wire from one of the footrests adjustment holes to one of the structural parts of the wheelchair below the seating area, and keeping it in tension. This assists in counteracting the pressure of the feet on the footrest, and takes strain from the printed part. We also wrapped the pipes in some duct tape, both to keep them together and to form a small buffer to reduce the strain on the plastic parts.
It is very much a “quick and dirty” model, not intended for permanent use. However, we hope that it will be helpful if you ever find yourself in the same situation.
We printed ours in PETG with 50% infill. I recommend printing it laying down on the cut ends of the rings so that the layers are along the length of the splint - this should give it some additional stability. It will require some supports to print either way.