1 / 2
Cellulose Swab dispenser for the Prusa Enclosure — image 1
1 / 2

Cellulose Swab dispenser for the Prusa Enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Cellulose Swab dispenser mounted in the top left front in the Prusa Enclosure

Rating
0 / 5
Likes
1
Downloads
14
Makes
0
Views
146
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

I like to use non-sterile, inexpensive cellulose swabs and IPA to clean my print bed.

This is a dispenser mounted in the top-left front, opposite the filament spool in the Prusa enclosure.

Printable Parts:

This dispenser has 3 printed parts: the (black) case, the (orange) removable holder, so that the swab-spool won't fall out by accident, and a small spacer.

Printing:

Print with supports, but place support-blockers over the nut inserts.

I've printed all 3 parts in 0.2mm structural, which worked fine.

Additional Parts:

You'll need 2 M3nS nuts and 2 M3x8 (12 is fine too) screws, ideally black.

Assembly:

Insert the nuts into the case, from the edge into the flap of the case.

Locate the 2 right screw holes. They are on the top-left front corner on the left-facing outer side, one on each metal part. They are similar to the ones used for the filament holder but on the opposite side.

Insert the screws from the outside.

Next, slide the spacer over the screws. The flat side goes against the edge of the acrylic window.

Now, align the case with the nuts and tighten the screws from the outside.

Place your swab roll in the correct toilet paper direction and feed the loose end through the hole.

Finally, slide the holder over the case.

Tags