AMS, EASY PRINT..STAY ON BED AND DON'T MOVE.... Y - Splitter, the best out there PC4-UM2 or 10mm ends
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is the best splitter, it actually prints and works.. connect more than one AMS, works smooth, use PC4-UM2 is best
- Rating
- 4 / 5
- Likes
- 14
- Downloads
- 113
- Makes
- 0
- Views
- 961
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution
connect multi AMS smoother and less issue than the bambu 4 way hub, Easy to Print, It prints without falling of plate and DOES NOT mover while printing to give you a high quality print that fit and works..
UPDATE: after printing make sure to insert the PC4-UM2 clips, then install the PTFE Tube, then your locking clip, then push the tube in a little more to make sure it bottom out inside for a tight fit so tube don't move.
if your tired of failed splitters that don't print or work correctly.. then look no further…
the PC4-UM2 the ends just snap in and can be picked up on amazon..
both of these print perfectly, i do recommend using the PC4-UM2 version, super light. for those who have a bunch of the standard 10mm ends they work perfect too
NOTE: the 10mm ends all 3 will need to be tapped by hand, easy to do if you have the tapered tap to do it with, if you don't have a tap already cheaper to but end for the PC4-UM2 version
NOTE: both version you just clip off the supports on bottom, they are one of the reasons these print so well, they stay on bed and prevent moving during printing.. i been using this for over 6 months on all my printer, never had a jam up in the splitter..
if you have feed back please let me know, if you print it and it works for you please like it..