1 / 3
AMS, EASY PRINT..STAY ON BED AND DON'T MOVE.... Y - Splitter, the best out there PC4-UM2 or 10mm ends — zdjęcie 1
1 / 3

AMS, EASY PRINT..STAY ON BED AND DON'T MOVE.... Y - Splitter, the best out there PC4-UM2 or 10mm ends

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

this is the best splitter, it actually prints and works.. connect more than one AMS, works smooth, use PC4-UM2 is best

Ocena
4 / 5
Polubienia
14
Pobrania
112
Wydruki
0
Wyświetlenia
957
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

connect multi AMS smoother and less issue than the bambu 4 way hub, Easy to Print, It prints without falling of plate and DOES NOT mover while printing to give you a high quality print that fit and works..

UPDATE: after printing make sure to insert the PC4-UM2 clips, then install the PTFE Tube, then your locking clip, then push the tube in a little more to make sure it bottom out inside for a tight fit so tube don't move.

 

if your tired of failed splitters that don't print or work correctly.. then look no further…

the PC4-UM2 the ends just snap in and can be picked up on amazon..

both of these print perfectly, i do recommend using the PC4-UM2 version, super light. for those who have a bunch of the standard 10mm ends they work perfect too

NOTE: the 10mm ends all 3 will need to be tapped by hand, easy to do if you have the tapered tap to do it with, if you don't have a tap already cheaper to but end for the PC4-UM2 version

 

NOTE: both version you just clip off the supports on bottom, they are one of the reasons these print so well, they stay on bed and prevent moving during printing.. i been using this for over 6 months on all my printer, never had a jam up in the splitter..

if you have feed back please let me know, if you print it and it works for you please like it.. 

Tagi