Thin and Sleek Raspberry Pi Camera Module Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A thin case for the Raspberry Pi Camera Module V1, V2, and V3. (V1/V2 should work as it mounts the same way for the V3.)
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 95
- Makes
- 0
- Views
- 505
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Update:
I remixed the case into a Z-Axis camera mount for the Ender 3/Ender 3 Pro. Check it out here:
https://www.printables.com/model/635606-modular-x-axis-raspberry-pi-camera-module-mount-fo
Info:
I wanted a super thin case for my Raspberry Pi Camera so that I could use that to make a webcam mount for my printer but couldn't find any that were sleek or held together well so I made my own! It's confirmed to work with the Module Camera V3 but V1/V2 should work as it mounts the same way but please prove me wrong if I am incorrect. You can even undo the connector without taking it apart by getting a small dull screwdriver or similar as shown in image 3 but please do not pry too hard! When putting it together, you can just hold the nut with your finger. It does not need to be too tight.
I plan to continue to make small changes when I see fit. I'm currently full-time in college so it will be some time. Feel free to modify as you like just please credit when posting. I hope to sometime in the future make a snap together design but I am still learning.
Print settings:
- Infill 100%.
- Layer height of 0.2mm.
- No supports are needed (Flip case by 180 degrees, flat side down).
Requires:
- x4 M2x10 screws.
- x4 M2 nuts.
Changelog:
V1:
- First version.
- + Added vents for the base model.