BX2440 2 Cricket LED
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.61 – €0.75 net (excluding VAT)
For file: BX2440-2-Cricket-LED_0.4n_0.3mm_PETG_MK3S_36m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.68 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 36 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Attach your Inspire Cricket LED monitor lamp below a Samsung BX2440 monitor.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 145
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Public Domain
Model
This adapter allows to attach your Inspire Cricket LED monitor lamp below a Samsung BX2440 monitor.
This gives a low, stealth light covers working area of the desk even under your hands if you lift them slightly. It does not hit your eyes, does not blind even at night.
Story
I've always wanted to a better spot light for my desk and I have having full room illuminated.
But with lamps high over the desk, all you get at the desk level are the sharp shadows of your hands.
Recently I've found this Cricket monitor lamp from Inspire. I've slapped it under the monitor with double-sided tape, but it never held for long (few days max).
Now this is more of a permanent solution, that is still fully reversible - no drilling or cutting.
Printing
You need to print two for full setup. The lamps cable goes between them.
For start you can cat it in ⅓ width in your slicer just to check for fit.
I would advise printing in PETG since it needs to bend to grab the monitor.
Other than that it's an easy print with no supports, with very little infill and a few (2) perimeters needed.