Photo Tripod Manfrotto digi 719B clamps replacement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Plastic clamps replacement for Manfrotto digi 719B Tripod
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 128
- Makes
- 0
- Views
- 847
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Plastic clamps in my old Manfrotto tripod became brittle and snapped off. Therefore the tripod was stashed away for a few years. As a natural hoarder I just did not have the willpower to finally throw it away.
That is until I got my hands on the 3D printer. I used this repair project was anexercise while learning the basics of onshape. A few test prints and parts did fit better than original.
It turned out that putting the parts together required some hacking. One cannot just brute force the hinge rods into place with a hammer. Clamps would simply snap off. One needs to gently apply the force while maintaining the pin position.
I sketched and printed a simple pin remover-installer tool that allowed me to gently apply force to the pin rods with a screw. It was a trial and error process with two or three prototypes that broke quickly. The last iteration is far from perfect, but it managed to get me thru to the end of the project.
The fit of my printed clamps turned out just a little bit too loose. This was solved by printing friction pads replacements (some were missing anyway) in different thickness variants.
I went with vibrant orange PCTG filament for the finish. Wanted to let it boldly show off the makey-iness of the owner :)
How to tweak
The onshape project is public: https://cad.onshape.com/documents/82592a674dffca8272988f6b/w/e711009bb69a2e2cb75aa9b7/e/6c5ddf57ea8aca5bdfa93f04?renderMode=0&uiState=650700a8615ee301c639c147
To quickly test fit of my parts before printing the whole part, I created a small ring part that was just an outline two connected rods cross-section. It is driven from the same sketch to ensure consistency.
How to print
Since this is a part that works under tension, it will require PET-G or PCTG at least. The part prints very well with Prusa Slicer's snug-type supports. Both affected surfaces will be hidden in the assembled tripod.
Friction pads are printed in upright position. This way the tension applied when the part is working will stretch layers instead of trying to separate them and break the pads eventually.
How to assemble
To place the hinge rod into the place, gentle and directed force will be required. I printed a guide tool that helped me drive the pin with a screw. The screw is attached with an M3 threaded insert. Printing the thread with plastic will most likely not work, because the required force is too large.
The tool has two sections - one for assembly and one for disassembling the part. Please see a photo that shows how the tool was attached to the leg.
