Gridfinity Lens Holders
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Gridfinity-compatible lens storage system using minimal material. Tested with Canon EF, EF-S and EF-M lenses.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 92
- Makes
- 0
- Views
- 819
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
There are a few lens storage models available, but they often use a lot of material. This version uses a Gridfinity compatible base-plate, and raised rings to stop the lenses from sliding around.
This is only intended for storing lenses on a shelf, or in a drawer, so unload them before attempting to move your lenses. These will stack on top of other Gridfinity bins, but I have removed the top-lip since most lenses will be tall enough to require too much material in the sidewalls.
This is modelled for Canon EF-M lenses which have a rear-cap size of 58mm, although it also works for smaller EF and EF-S lenses with a diameter of 63mm or less.
Three versions are available:
- 2x2 - Stores 1 lens
- 2x5 - Stores 2 lenses
- 5x5 - Stores 5 lenses
Print Settings
Layer Height: 0.20mm
Supports: None required
Infill: I used 20% Gyroid - this is only required on the 5x5 model
Filament used: Kingroon PLA Black