Baby Sidon - multi-colour print
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Even the mighty Prince of the Zoras was once a helpless hatchling
- Rating
- 0 / 5
- Likes
- 6
- Makes
- 0
- Views
- 295
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
Printing tips:
This is a 5 colour model. You can get away with four colours if you use only one shade of red instead of two (simply assign both reds to the same filament, or fill in the light-red highlights using the paint bucket tool).
It will balance better if you make the tail heavier than the head. Adjust the infill/perimeters in different parts of the model to help with this (using modifiers in your slicer). Unfortunately, because of the internal perimeters inherent to multicolour printing, the head will be a lot heavier than the tail if printed in multicolour. You can compensate for this with very dense infill in the base, or simply help the model balance with a small piece of tape on the underside of the tail after printing.
Filaments used:
eSun PLA+: Black, Cold white, Fire Engine Red, Red, Yellow