Universal Automatic sliding gate track or trail.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rail motor for automatic/motorized sliding gates.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 66
- Makes
- 0
- Views
- 510
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
Universal replacement part for automatic sliding gate track or trail.
Compatible with any plastic rail based motor.
Length: 26cm.
Printability:
- Supports: This model is pre-supported.
- Orientation: Must be printed vertically - the layer lines will be perpendicular to the motor force.
- Printing instructions:
1. Load Automatic_Gate_Track_Trail.stl
2. Load Infill_Modfication.stl as a modifier for the main object and set its fill to 100%. This will make the areas around the holes solid.
- Recommended settings:
Perimeters: 4. If your motor is designed for gates weighing more than 600 kg, consider increasing the perimeters - remember that the number of perimeters is more important than the infill in increasing the strength of a part.
Infill: 30% - honeycomb or lines or grid.
Layer height: 0.2 or smaller. Do not use adaptive layers hight.
Brimm: It should not be necessary. However, if you experience printing failure - consider using.
Speed: This part have much overhangs, too much speed may inrease risk of printing failure.
- Assembly:
1. Remove supports (a slight side to side force should remove it easly).
2. Check if holes where printed with the correct diammeter. The depth of the hole is 6 mm, check that the thread length of your screw must be less than 6 mm plus the thickness of the base of your gate - if necessary, use alleys. Trying to screw in deeper will break the part.
3. Screw part in place.