Universal Automatic sliding gate track or trail.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rail motor for automatic/motorized sliding gates.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 510
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
Universal replacement part for automatic sliding gate track or trail.
Compatible with any plastic rail based motor.
Length: 26cm.
Printability:
- Supports: This model is pre-supported.
- Orientation: Must be printed vertically - the layer lines will be perpendicular to the motor force.
- Printing instructions:
1. Load Automatic_Gate_Track_Trail.stl
2. Load Infill_Modfication.stl as a modifier for the main object and set its fill to 100%. This will make the areas around the holes solid.
- Recommended settings:
Perimeters: 4. If your motor is designed for gates weighing more than 600 kg, consider increasing the perimeters - remember that the number of perimeters is more important than the infill in increasing the strength of a part.
Infill: 30% - honeycomb or lines or grid.
Layer height: 0.2 or smaller. Do not use adaptive layers hight.
Brimm: It should not be necessary. However, if you experience printing failure - consider using.
Speed: This part have much overhangs, too much speed may inrease risk of printing failure.
- Assembly:
1. Remove supports (a slight side to side force should remove it easly).
2. Check if holes where printed with the correct diammeter. The depth of the hole is 6 mm, check that the thread length of your screw must be less than 6 mm plus the thickness of the base of your gate - if necessary, use alleys. Trying to screw in deeper will break the part.
3. Screw part in place.