Stihl AP battery carrier
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€8.56 – €10.47 net (excluding VAT)
For file: stihl-battery-pack-carrier_0.8n_0.4mm_PETG_XLIS_4h37m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €9.52 excluding VAT (range midpoint).
- Weight reported by the author
- 237 g
- Print time reported by the author
- 4.62 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a carrier for two Stihl AP batteries. Easier to transport and it keeps the contacts away from dirt.
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 291
- Makes
- 3
- Views
- 1,326
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
This is a carrier for Stihl AP batteries, it will fit any battery of the AP series. I got fed up of these (very expensive) things sliding around in the back of my car. It both makes them easier to carry as well as protects the batteries from dirt.
The bottom is closed, so it can be placed on for example wet grass.
Print settings:
Make sure your bridging settings are correct. There was a little bit of sagging on the handle, but it actually makes it a little bit more comfortable.
Also make sure layer adhesion is good, or the handle will snap off eventually.
I optimized the design for a 0.8 mm nozzle. I printed it with 0.4 mm layer height, this is fine for a structural print.