1 / 2
RCA / Cinch Y-adapter (stereo to mono downmix for subwoofer) — image 1
1 / 2

RCA / Cinch Y-adapter (stereo to mono downmix for subwoofer)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An RCA Y-adapter for stereo to mono downmixing to connect subwoofers with a single RCA input to stereo RCA sources.

Rating
0 / 5
Likes
5
Downloads
39
Makes
0
Views
420
Reviews
0

Updated at source:

Model information

Category
Audio
License
Creative Commons — Attribution — Noncommercial — Share Alike

An RCA Y-adapter for stereo to mono downmixing to connect subwoofers with a single RCA input to sources with stereo RCA outputs. The box design is simple and not very fancy.

The circuit is inspired by multiple sources [1, 2] and should work fine for most line-level signals in consumer audio. No warranties, though. You will need to re-tune the subwoofer level after installing the adapter.

 

Bill of materials

  • 2 male RCA cable ends (approx. 15 cm long)
  • 1 female RCA socket with M7 or M8 thread
  • 2 resistors with roughly 5 kOhm
  • 2 short pieces of flexible cable (about 4 cm each)
  • 1 M4x12 screw (M4x10 should work as well)
  • 2 cable ties for strain relief
  • Soldering equipment

 

Build process

  • Print both case parts
  • Install the female RCA socket into the bottom part of the case
  • Solder one resistor each between the positive (center) lead of each RCA cable and the RCA socket
  • Solder one short wire each between the negative (outer shielding) lead of each RCA cable and the RCA socket
  • Insulate blank metal parts with tape, where required
  • Install one cable tie on each RCA cable inside the printed case as a strain relief
  • Put on the top case and install the M4x12 machine screw to secure it in place

 

Print settings

  • Layer height 0.2 - 0.24 mm
  • Line width 0.42 mm
  • Infill 25 - 35%
  • 4 wall lines
  • 5 top & bottom layers
  • Supports enabled (only on build plate)

Tags