1 / 7
Portable Solder Fume Extractor
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed the design by @lewosh to omit the battery, omit the status LED, and redesign the fan/filter assembly
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 143
- Makes
- 2
- Views
- 1,020
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of lewosh's battery operated solder fume extractor. I made the following changes:
- Base: Closed the opening for the battery status indicator and removed built-in support structures (I prefer to use PrusaSlicer organic supports)
- Base Front: Closed the opening for the status LED reduced width by 0.5 mm for an easier fit into the base
- Base Bottom: Closed the opening for the battery compartment and associated screw holes
- Fan Housing, Fan Filter Compartment, & Fan Filter Housing:
- Moved cord hole to opposite side to reverse the fan orientation (pull air in through filter rather than push air out through filter)
- Removed filter installation slot and changed so the filter (and filter compartment) just sits inside between the fan housing and fan filter compartment
- Added screw holes in the corners to allow for assembly with four M3 x 50 mm screws & M3 nuts
Parts:
- PWM Motor Speed Controller
- 5.5 x 2.5 mm Female Socket Panel Mount Connector
- KCD1 2 Pin 250V 3A SPST Black Boat Switch 21x15
- Noctua NF-F12 iPPC 3000 PWM Cooling Case Fan
- 12V 1A Power Supply, 100-240V AC to DC 12 V
- Activated Carbon Filter (needed trimming to fit)
- M4 Heat Set Inserts
- M4 Screws
- M3 x 50 screws & M3 nuts