1 / 6
CP2102 case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
- PLA
- 0.2 mm layer height
- 20 % infill
Place the PCB between the two parts so that the pins are covered and the board lies on top of the support pillars. Glue the two parts with super glue.
If the board slides inside the two parts. Pull on the USB side and add a bit of glue between the shell and the USB.