1 / 8
1541-II Power Guard Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple housing for the 1541-II Power Guard project by Stefan Wagner.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 0
- Views
- 189
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple housing for the 1541-II Power Guard project by Stefan Wagner.
Requires a rubber seal ring with an outer diameter of 7-8mm. Optionally also requires two pieces of acrylic fiber 2x20mm inserted into the top part and fixed using UV glue.
Print both parts with the outer side facing the print bed. No support required.
Please note the license for this design! It does NOT allow for commercial use.