YAHME3 (left) -Yet Another Hemera Mount for Ender 3pro

YAHME3 -Left Flipped Hemera Mount for Ender 3pro  

The hemera on this is reversed - i forget why - But its based on the existing metal  x carriage mount so you do not have to dissasemble the whole printer

Uses stock backplate leaving access to all attaching screws

• bl touch mount
• use of stock metal x axis plate and most creality stock  bits (including blower fan)

WARNING: hotend and bl touch will be moved from original position so you will need to adjust ends stops  and firmware settings to match!! forgetting this can cause your hotend to crash into the bed badly

• bltouch is offset 0mm(y) and 60mm(x) to the left and when retracted should be 2mm(z) up
• bltouch z offset canbe affected by your configuration of your hotend nozzle and type of heatbreak (ie diffrent for volcano or supervolcano or how many turns you twisted in the hotend tip)

Assembly and printing

I printed in high temp resin.. (because i can avoid wierd supports ) but you could print in ABS and print at 40% infill  for strength with 4 walls

1. print one each of backplate, blowerduct
2. assemble backplate first to original steel plate on x carriage
3. use original creality screws from teh fan shroud to attach in same screw locations  the pins for hoten will add support to backplate)
4. then attach hemera direct kit 
5. Attach Bltouch
6. attach fan duct and blowerfan
7. follow hemera tuning and firmware instructions for your mainboard used  to set propper steps and PID tuning and recheck belts are properly tensioned and bed re-leveled by hand before trying to operate fully