XT60 Connectors Plus Strain Relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My take on XT60 connectors, both Male and Female versions. Plus my take on a strain relief for 12 awg wires.
- Rating
- 5 / 5
- Likes
- 52
- Downloads
- 487
- Makes
- 1
- Views
- 2,398
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
These are my take on some XT60 connectors.
They are made to fit 3.5mm (4mm OD) connectors. They should be press fit, I had to use a small vice to press mine in place. On the male connector, I added a bit of super glue after to hold them in place as there is less area to hold them in place.
I tested my prints with some generic XT60 connectors, and both fit the standard connectors with no modifications.
I printed mine in Polymaker PC @ 0.2mm and they handled the heat of soldering easily.
Print with the solder end to the printer bed, no supports needed.
I printed the strain relief in TPU @ 0.2mm, and they slide on of the wires after soldering.
The strain reliefs have a small rim that fits into the area around the contacts on standard XT60 connectors. Make sure you print with this rim facing up. No supports needed. Note: You may have to trim off this rim when using these with my XT60 connectors.