1 / 2
Sony WH-1000XM5 arm repair — image 1
1 / 2

Sony WH-1000XM5 arm repair

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Clamp one of the arms of Sony's WH-1000XM5 headphones together, in case the part has broken.

Rating
5 / 5
Likes
42
Downloads
766
Makes
6
Views
4,668
Reviews
5

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

One of the arms on my Sony WH-1000XM5 headphones snapped. This print clamps over the arm, using 3 M3 nuts, and 3 M3 8mm cap screws to hold it together. The arm on mine broke with conveniently ragged edges, so alignment was very easy.

I printed in PLA, and made it solid because it's a very small item. No supports are necessary, but you will have to realign the model to the print bed.

I'm still learning OpenSCAD, so there are some rough aspects to this model, especially the sharp corners on the outside.

Edit: I added a v2 that is slightly narrower, has rounded corners, and adds a fourth screw. The original would occasionally touch the side of my head, especially when putting them on/taking them off.

Tags