Chain keepers: dog fang & various styles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
chain keeper to prevent derailment of the chain towards the inside of the bike
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 46
- Makes
- 0
- Views
- 267
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Worked on this throughout the years – the design has evolved a bit.
Rev 6
As of 2023-10-14, latest rev is rev 6.
Compatible with 31.8 mm seat tubes.

Hardware
M4 x 16 CSK screw
M4 nut, ordinary
if I have problems with the joint loosening over time, I will update this model to take a locknut instead, but I'm guessing the stretch in the band will be sufficient to provide anti-loosening properties – we'll see
PLA is sufficient for these stretchable band clamps.
Rev 6 installation
M4 x 16 CSK bolt + regular hex nut
Kind of awkward to mount, rev 7 will relocate the clamp elsewhere for ease of access
I was trying to save material, but this is too painful to use
I will wait until this one breaks or something before testing rev 7


Future improvements
Extend fang down so it doesn't bottom out on weld
Flip nut pocket upside down to maintain support-free printing
Move nut pocket to non drive side or at least 90 deg on middle plane of bike so it's accessible from the non-drive side
Rev 5
Rev 5 finally cracked after about a year
was an experiment to see how well M4 tapped threads straight into the PLA material would work