1 / 3
VW Lupo (Seat Arosa) drink and cash drawer caps — image 1
1 / 3

VW Lupo (Seat Arosa) drink and cash drawer caps

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Drawer caps with matching latches for a Volkswagen Lupo. They should match for Seat Arosa as well.

Rating
0 / 5
Likes
18
Downloads
167
Makes
0
Views
1,428
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

These were missing from my Lupo, so I borrowed the caps from my friend's Arosa and I based the model from them. 

I printed these cut in the middle (see image below) in PrusaSlicer, and glued them together with superglue (like Loctite), and then sanded them down with 600-grit wet sandpaper, and sprayed varnish in the end.

 

Print suggestions:

  1. Suggested Material: ABS, ASA or PETG. They're thin parts so PLA might warp in warmer climates.
     
  2. Nozzle: 0.4mm (can't go with bigger cause details for the latches are needed)
     
  3. Parameters/infill: at least 3 params, with at least 15% infill. You could print 100% infill for a more sturdy print
     
  4. Layer height: 0.16mm or 0.2mm work fine
     
  5. Supports: The ones in the photos are printed without supports and they latch just fine.

Tags