1 / 3
VW Lupo (Seat Arosa) drink and cash drawer caps
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drawer caps with matching latches for a Volkswagen Lupo. They should match for Seat Arosa as well.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 167
- Wydruki
- 0
- Wyświetlenia
- 1428
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (21)Powiązane
These were missing from my Lupo, so I borrowed the caps from my friend's Arosa and I based the model from them.
I printed these cut in the middle (see image below) in PrusaSlicer, and glued them together with superglue (like Loctite), and then sanded them down with 600-grit wet sandpaper, and sprayed varnish in the end.

Print suggestions:
- Suggested Material: ABS, ASA or PETG. They're thin parts so PLA might warp in warmer climates.
- Nozzle: 0.4mm (can't go with bigger cause details for the latches are needed)
- Parameters/infill: at least 3 params, with at least 15% infill. You could print 100% infill for a more sturdy print
- Layer height: 0.16mm or 0.2mm work fine
- Supports: The ones in the photos are printed without supports and they latch just fine.