1 / 5
Staff of Magnus Skyrim PVC Remix — image 1
1 / 5

Staff of Magnus Skyrim PVC Remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A remix of a great design of Staff of Magnus Skyrim. Made to use PVC and room for arduino and rgb leds

Rating
0 / 5
Likes
73
Downloads
188
Makes
0
Views
1,642
Reviews
0

Updated at source:

Model information

Category
Props
License
Creative Commons — Attribution

My nephew wanted a staff for Halloween, saw this design and loved it. I wanted to make it a little more sturdy so took out middle section of staff and replaced with PVC. Also took off the bottom light crystal and opted for a less breakable one without lighted bottom section since it will probably be dragged on the ground alot. Also added a control box for 2 buttons and power switch. One button would be simple on off and the other would change color. Enough room for a nano and 9v battery in box.I wanted to do more and make a little smaller but ran out of time. End result came out great.

Printed all parts without support on my Ender Max Neo.  Parts a little loose on pvc but one layer of painters tape will hold it tight. I drilled a hole in the base of control box to attached firmly to pvc with screw. 

Ill try to add more to build when I have time but basically measure out wire LONGER than needed and feed thru the top before gluing together. Glue together then put staff head on pvc and drill a hole in the PVC right under the part so you can put wires thru top and right into pvc and then back out the hole into the control box.

 

EDIT: I have uploaded version 2 of the bottom crystal, the control box and lid. I have not test printed them yet but just a little slimmer version of the original. everything should fit the same just thinned out the outer skin so it wasn't quite as bulky. Use a brim to make sure it stays on bed but should print fine.

Tags