Geberit dual flush button
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Geberit buttons printed in one piece - no springs or another parts. Fits as Sigma etc original part.
- Rating
- 5 / 5
- Likes
- 68
- Downloads
- 728
- Makes
- 4
- Views
- 4,743
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
Finally visible is bottom area of the print - type of bottom fill pattern make different looks. I recommend to use textured print sheet. As visible is mostly bottom side, no need to push printer to high resolution.
2023 11 01: New version of file uploaded.
This updated version is more lightweight and stronger. It was tested on 0.8mm needle / 0.4 mm print layer / 100% density. Print cost cca 150g of fillament and 3:12 min on MK4.
Width of this print is 246 mm what is quite near the limits, so carefully place on the plate.
Bridges (what works as springs) are 27mm - if slicer will protest, adjust bridging speed slightly. No support needed!
Very large bottom surface of model makes perfect print sometimes tricky, keep constant temperature..
I made it because organic PLA and fraction of original price … enjoy!