Sprite extruder partcooling for Volcano length hotends
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mod of the reindeer fanshroud to enable use of volcano length hotends like the K1 ceramic heater hotend. It…
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 63
- Makes
- 1
- Views
- 815
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mod of the reindeer fanshroud to enable use of volcano length hotends like the K1 ceramic heater hotend. It could also work with other, not as long but longer than stock hotends, I haven't tested that though.
I modded the mounting part to sit a bit lower and while I was at it, to be fixed at both sides, so it can't wobble during x-moves. It also has a little surface to stick a nozzle LED on with double sided tape if you need it. See link to my zero y backplate below for wiring it on your partcooling fan
5015 fan gets fixed with a single M3x18 screw
Print in heat resistant filament @0.2mm, air outlet/inlet down, no supports.
Works great with this zero-y backplate.
The original is from Kinematic Digit
Category: 3D Printer Parts