Sprite extruder partcooling for Volcano length hotends
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mod of the reindeer fanshroud to enable use of volcano length hotends like the K1 ceramic heater hotend. It…
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 63
- Wydruki
- 1
- Wyświetlenia
- 815
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mod of the reindeer fanshroud to enable use of volcano length hotends like the K1 ceramic heater hotend. It could also work with other, not as long but longer than stock hotends, I haven't tested that though.
I modded the mounting part to sit a bit lower and while I was at it, to be fixed at both sides, so it can't wobble during x-moves. It also has a little surface to stick a nozzle LED on with double sided tape if you need it. See link to my zero y backplate below for wiring it on your partcooling fan
5015 fan gets fixed with a single M3x18 screw
Print in heat resistant filament @0.2mm, air outlet/inlet down, no supports.
Works great with this zero-y backplate.
The original is from Kinematic Digit
Category: 3D Printer Parts