1 / 3
Logitech MX Master 3 Case (8mm dia X 3mm magnets)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adjusted model for 8mm diameter and 3mm thick magnets. Smallest magnets I could find at Ace Hardware.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 82
- Makes
- 0
- Views
- 656
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
I printed in PLA 0.3 draft layer height with brims.
I had to clean up magnet holes a bit before magnets fit snugly in. There was a bit of a gap between front and back so I used a soldering iron to further sink the magnets in place. One magnet would not stay in place so I used a bit of super glue.
For more info look at original by shakeNbake08 at https://www.printables.com/model/213059-logitech-mx-master-3-case