Bathroom/kitchen organizer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Soap-sponge-toothbrush-razor-shampoo-whatever holder in one for kitchen or bathroom
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 112
- Makes
- 1
- Views
- 593
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bathroom/kitchen organizer:
- soap/sponge/rubber duck holder with drip chute
- toothbrush/razor/brush/toothpaste holder
- space for shampoo/dishwasher
- …
The prototype was printed in PLA: ~110g filament, ~4+h print time, minimal amount of support
+ 4 TPU legs to prevent slip and give some clearance so water can drip out at the bottom
+ a bottom tray if needed (this does not cover the soap holder's drip chute, that should stick out over the sink)
For future easy clean I will print the final model in ABS and use acetone vapor smoothing.
The soap tray is at 33°, consider printer capabilities if choosing not to add support - X1C can handle it without support.
Dimension without tray: width: 174mm * depth 104mm base + ~23mm chute * height 102,2mm + 3mm legs
Tray: 186.5mm * 116.5mm