Bathroom/kitchen organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Bathroom/kitchen organizer:
- soap/sponge/rubber duck holder with drip chute
- toothbrush/razor/brush/toothpaste holder
- space for shampoo/dishwasher
- …
The prototype was printed in PLA: ~110g filament, ~4+h print time, minimal amount of support
+ 4 TPU legs to prevent slip and give some clearance so water can drip out at the bottom
+ a bottom tray if needed (this does not cover the soap holder's drip chute, that should stick out over the sink)
For future easy clean I will print the final model in ABS and use acetone vapor smoothing.
The soap tray is at 33°, consider printer capabilities if choosing not to add support - X1C can handle it without support.
Dimension without tray: width: 174mm * depth 104mm base + ~23mm chute * height 102,2mm + 3mm legs
Tray: 186.5mm * 116.5mm