1 / 2
Lifecounter cover with inset screws
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cover that allows screws to sit flush with the top.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 39
- Makes
- 1
- Views
- 175
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Miniature Gaming Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an alternate version of the cover part from the original make that allows the screws to sit flush with the top of the unit.
In the original make 2x M3x12mm screws are used, however if you are using this part the amount of material the screw is going through is slightly less. I used 10mm screws and it worked fine.
Also, I had some issues with the part warping off the bed near the viewing hole (printing with the flat surface on the part towards the bed). I ended up just increasing the temperature of my bed by a few degrees and that resolved the issue.