Smooth Bearing 608 (22x8x7mm) print-in-place
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print-in-place 608 bearing (OD 22 mm, ID 8 mm, Width 7 mm) with 12x 5mm ball-rollers, with ±0.1mm tolerances.
- Rating
- 4.333 / 5
- Likes
- 43
- Downloads
- 763
- Makes
- 2
- Views
- 2,083
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a print-in-place 608 bearing with 8x 5mm ball-rollers separated with distancers. I made it using ±0.1mm tolerances, as all the other models that I found either were too wobbly due to higher tolerances, or were difficult and unreliable to print.
When printed in PLA with 0.25mm nozzle it is quite enough for a spool holder or some other light-duty appliance. I successfully print them at 0.12mm layer height, 0.25mm nozzle and Input Shaper.
If you have a quality filament and a good, well-tuned printer, it will probably even work with 0.4mm nozzle.
Dimensions
- Outer diameter: 22mm
- Inner diameter: 8mm
- Height: 7mm
- Tolerance between the rollers and the rings: ±0.1mm
Print Settings
0.12mm STRUCTURAL @MK4IS 0.25 PrusaSlicer Profile with:
- 50% Rectilinear Fill
- 0.1mm Elephant Foot Compensation
- No supports required.
Post-printing
After printing use an X-acto knife or a needle to separate the rollers from the distancers and lubricate with a few drops of silicone oil.
How it works
Video here.