1 / 3
Built Plate Stand with Cooling Fan
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I slapped this together to greatly speed up cooling down built plate in between prints on a Voron Trident.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 30
- Makes
- 1
- Views
- 359
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
The switch is roughly 10mm by 6mm and is used to simply turn the fan off when not in use. Once the print is done I pop off the plate and set it down, then turn on the fan. Within about 3 minutes it has cooled and print pops off, then I slap it back into the printer and its ready to go again.