1 / 1
Flashlight Diffuser for Streamlight ProTac HL-X
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Flashlight Diffuser for Streamlight ProTac HL-X
Settings
- Surface Mode: Surface (no top or bottom) OR Both (be sure to flip the model 180 so the top will be printed and the bottom will be open)
- I recommend rotating the model 180 to print the top fully (it should print like an ice cream cone)
- Spiralize Outer contour (vase mode)
- Layer Height: 0.2
- Wall width: 0.82
With these settings my print was snug on the crown of the flashlight and created a good seal. It “pops” when detaching it from the flashlight. You might need to adjust your wall width depending on your printer to get a good fit.