AMS Riser Tab for P1P with ARC Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This prevents the riser from sliding around loose on top of the P1P using the ARC Enclosure
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 23
- Makes
- 0
- Views
- 570
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Problem: I'm under the assumption most of these lid risers for the AMS only work with P series printers using the official enclosure (P1S) that have a sort of lip at the top of the panels that “wedges” these risers in place. However, when putting them a P1P using the ARC Enclosure, it will only sit flush on top and not in any recess which would allow it to be bumped and slide around.
The Solution: I redesigned the original Arc Enclosure tabs to wedge in to the side of this riser keeping it from being able to slide around. Just print 6 and replace the original Arc ones with these and you're set. You'll also need something in that open hole in the front right to keep it from sliding forward. I added a little plug but you can skip it though if you already have something in it.
It also dawned on me my plexiglass top piece screws for the handle are wider so I had to make that cut out bigger AND the front corners are a pointed 90 degree angle. The original design (Ken Mills Remix) I used had a curved edge which wouldn't allow it to fit, so I'd uploaded those as well if anyone needs em.