MMU2 Buffer Sidefeeder (for LACK Enclosure V2)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.45 – €1.78 net (excluding VAT)
For file: MMU2BufferSingleSideFeeder_0.2mm_PETG_MK3S_1h52m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.62 excluding VAT (range midpoint).
- Weight reported by the author
- 16 g
- Print time reported by the author
- 1.87 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
To feed filament into the mounted buffer to the MMU2 without removing or reconnecting the already connected tubes.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 33
- Makes
- 0
- Views
- 801
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
To feed filament into the mounted buffer to the MMU2 without removing or reconnecting the already connected tubes.
You need 5 short PTFE tubes (around 7cm each) and 10 PC4-M10 connectors. I use ID 2mm PTFE for the short part (most of my other PTFE are ID2.5mm) because you want some friction in that part to prevent the filament being pushed out of the buffer. For the same reason you should adjust the angle the feeders are mounted on the enclosure to make sure the filament ist not pushed back. Just load to nozzle and then unload the filament to check before you fix the feeder in place. If you mount the feeders similar to the way on the photo it should work nicely. Be aware that depending on where you fix the feeders you might end up above the cut-out in the enclosure V2 top (like I did). In this case using a short screw and nut is better than a normal screw.