SOTABEAM CARBON 6 guy line system
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This project is a guy line system for the SOTABEAMS CARBON 6 antenna mast.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 52
- Makes
- 0
- Views
- 364
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a guy line spreader and base with pegs and line tensioners.
The line spreader (flange) will slop fit onto the joint between the second and third tubes of the mast.
The line goes from the bast that holds the foot of the mast, through the begs and to the line spreader at the top.
its simple, easy to pack, easy to use.
I used Prusament PETG, but any filament should work.
I also used organic support inside the top flange, as there is a 1mm ledge as it gets narrower at the top in order to sit on the top of the second tube.
Both the top flange and the base plate are slip fit onto the mast.