SOTABEAM CARBON 6 guy line system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This project is a guy line system for the SOTABEAMS CARBON 6 antenna mast.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 364
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a guy line spreader and base with pegs and line tensioners.
The line spreader (flange) will slop fit onto the joint between the second and third tubes of the mast.
The line goes from the bast that holds the foot of the mast, through the begs and to the line spreader at the top.
its simple, easy to pack, easy to use.
I used Prusament PETG, but any filament should work.
I also used organic support inside the top flange, as there is a 1mm ledge as it gets narrower at the top in order to sit on the top of the second tube.
Both the top flange and the base plate are slip fit onto the mast.