Attractive Fan Duct
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to mount 4x120mm fans to a grid which are magnetically attached to the duct.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 35
- Makes
- 0
- Views
- 558
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
Connect four 120mm fans to any opening that fits two. I used fans that I had lying around, but I would recommend going for pressure optimized fans if you have the choice. I use this to get additional circulation for a walk-in closet.
All parts except the main-duct were printed without support in PLA on a Bambulab X1C. The duct had support underneath the magnet-holes. Some parts need to be printed diagonally and vertically to have enough space on the plate. You could easily slice them in half and print in two sessions if you want higher quality parts. You can see that I just printed half of the filter grid because two of my fans still had grills.
You'll need 8 10x10x5mm magnets to attach the fans to the duct.
My designs are released under a public domain license: You can do whatever you want with them. I put as much care and attention to detail into them as if they were commercial products. If my design solved a problem for you, I'd like to invite you to donate me a quarter of a filament spool. These little gestures go a long way and are quite motivating. Thank you!
