1 / 4
Induction Coil Heater/Sterilizer
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple induction heater design to be used in home mycology or any other work that requires heating or sterilizing.
- Rating
- 0 / 5
- Likes
- 46
- Downloads
- 732
- Makes
- 2
- Views
- 3,192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Print flat sides down no supports.
To use, plug into 12v 10amp power supply. Insert tool into coil and hold down the button until it glows, this usually takes a few seconds.
Assembly instructions:
- Insert both the button and the power supply port into the lid and base and secure respectively.
- Push zip through the channel in the base.
- Position and attach the coil with the zip tie.
- Route the negative lead from the power supply port into the negative connection on the board.
- Splice together the positive lead from the power supply into one of the leads on the button.
- Route the free lead from the button to the positive connection on the board.
- Close together and fix with 12mm m3 bolts
*assembly notes: solder the coil with 30mm OD to OD on the leads, you can use calipers or the base as a guide for this so it fits in place.
Parts (amazon affiliate):
Induction Coil, Power Supply, Button, m3 bolts, metal power supply port