Gaggiuino - Nextion24 Front Mount Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a magnetically mounted alternative to the original parts that replace the rear water filler housing.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 77
- Makes
- 1
- Views
- 1,068
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This is an alternative housing and placement of the Nextion24 LCD screen used for Nextion based Gaggiuino. The housing has an an opening for the SD card slot at the bottom and attaches to the cup warmer plate by magnet. The two small washers are used to prevent the M3 screws from bottoming out in the housing.
Print setup suggestions
- Print with the front face on the printbed to minimize required supports.
- Supports should only be required in two small locations at the cable channel. Avoid adding support near the pin as this can negatively effect the interface with the LCD mounting hole.
- I've used PLA and have not noticed any temperature related issues after a few weeks of use however PETG would be a safer material choice.
Additional BoM required:
- [Qty.2] Neodymium Magnet - dia. 10mm x 3mm
- [Qty. 2] M3x5 panhead screw
- Long enough cable to reach your Gaggiuino from the install location
- Glue to attach magnets
Revision History
R2.009 - Adds simple fastening to backpanel
R2.009 - Increases magnet hole size from 10mm to 10.2mm to accommodate easily source-able 10mm magnets
R2.009 - Adds separate models for screw washers
R3.010 - Improves fastening tolerances
R3.010 - reduces overhangs for printability
R3.010 - Increased lcd cover depth to prevent issue where it touches the lcd panel and causes problems with user inputs