1 / 4
Magnetic Backplate for Voron V0.2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A magnetic backplate for the Voron V0.2, that can be printed on the Voron 0.2. Optional fan support.
- Rating
- 5 / 5
- Likes
- 73
- Downloads
- 271
- Makes
- 16
- Views
- 1,659
- Reviews
- 15
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a magnetic backplate for a Voron V0.2 that replaces only the lower rear panel. It can be printed on a voron 0.2 itself and fastens together with clamps.
Depending on your printer, some tolerances might be too tight and need some light sanding. Only the shoes require some support for clean magnet holes. Simply screw through any fan holes that are covered.
V2.2
- Increased fan screw hole outer diameter to 7.4mm so fan screws sit flush
- Added One Piece Models
V2.1
- Added mesh templates for all backplates – print with only infill and fixate with clamps and glue
- Added support for NF-PL14
V2.0
- Versions for internal 4010 and 8010mm fans - easier to print and don't protrude outwards!
- 80mm external now comes pre-supported (just print as is and screw through the thin layer under the screwhole)
- ZipTie mounting holes for fan wiring
- USB cable holes on all sides
- M3 Hole for additional mounts (tbd)
- Completely covers the whole backpanel
- Clears with URBI BTT SFS v2
Old shoes and clamps are compatible with V2 and can be reused.
Hardware Parts
- 4x M3x6 BHCS for mounting the shoes
- 2x M3x30 BHCS for extending the spoolholder
- 8/16 Magnets 6x3mm round (you can probably get away with half of them)
- Optional: 80mm Fan, e.g. Noctua NF-A8 PWM, 4010 or 8010 fans
Credits for Fan Models:
- https://grabcad.com/library/noctua-nf-a9-14-1
- https://grabcad.com/library/noctua-nf-a8-pwm-80x80x25-1
- https://grabcad.com/library/nf-p14-flx-fan-1