SKADIS Screwable Nuts (not T-Nut)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nuts to screw things to the SKADIS Board from the front or back side (M2 and M3 threaded)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 25
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
I sometimes use the T-Nuts to put things to the SKADIS wall, but i now had a selfmade small board where i had to mount a hook from the backside. First i used the T-Nut, but as it i was not confident with this, i made an threaded nut with a chamfer, which fits in the the SKADIS hole and this looks nicer. For the back side i did the same without a chamfer, because i can always reach the backside and so there is no need to use a t-Nut or a hook.
Printing:
Layer height should be not greater then 0.12mm because of the thread.
The thread has to be in the z-axis.
I use PETG for this , but PLA or any other material should be fine.