SKADIS Screwable Nuts (not T-Nut)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nuts to screw things to the SKADIS Board from the front or back side (M2 and M3 threaded)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I sometimes use the T-Nuts to put things to the SKADIS wall, but i now had a selfmade small board where i had to mount a hook from the backside. First i used the T-Nut, but as it i was not confident with this, i made an threaded nut with a chamfer, which fits in the the SKADIS hole and this looks nicer. For the back side i did the same without a chamfer, because i can always reach the backside and so there is no need to use a t-Nut or a hook.
Printing:
Layer height should be not greater then 0.12mm because of the thread.
The thread has to be in the z-axis.
I use PETG for this , but PLA or any other material should be fine.