1 / 3
Straw Cap
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Straw cover for straws with a 10mm outer diameter
- Rating
- 0 / 5
- Likes
- 33
- Downloads
- 386
- Makes
- 0
- Views
- 1,553
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
This straw cap was specifically measured and designed for straws used by Simple Modern tumblers, but it should fit all straws with a 10mm outer diameter.
The piece was sliced in Cura and then printed on Ender 3 S1 Pro using a Sonic Pad with the following settings. It had a total print time of about 48 minutes.
Infill: 25-30% of Cross 3D
Print speed: 30mm/s
Extruder temp: 235°C
Bed Temp: 55°C
No supports were used
There is also the file for just the strap in case you need to lengthen or shorten it. The strap is not detachable from the straw mount or cap pieces.