Straw Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Straw cover for straws with a 10mm outer diameter
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 386
- Wydruki
- 0
- Wyświetlenia
- 1553
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This straw cap was specifically measured and designed for straws used by Simple Modern tumblers, but it should fit all straws with a 10mm outer diameter.
The piece was sliced in Cura and then printed on Ender 3 S1 Pro using a Sonic Pad with the following settings. It had a total print time of about 48 minutes.
Infill: 25-30% of Cross 3D
Print speed: 30mm/s
Extruder temp: 235°C
Bed Temp: 55°C
No supports were used
There is also the file for just the strap in case you need to lengthen or shorten it. The strap is not detachable from the straw mount or cap pieces.