Boot Disk phone stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Upcycle your 3.5" floppy disk to make a phone stand, now with boots and a tail.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 27
- Makes
- 1
- Views
- 285
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
Print the model, insert the 3.5 inch floppy disk and use it as a phone stand.
Floppy is not included, dig your own somewhere in the attic or print
a “save icon” like this one: https://www.printables.com/model/510115-35-floppy-disk
The disk slot is thin enough to hold the diskette tight, so it's may be a bit harder to insert a 3d-printed “floppy disk" than a genuine diskette.
Phone shelf is wide enough to hold even a thick extreme phone case.
Any filament, no supports.
I printed it on Bambu P1P with Spectrum PCTG Premium filament, 0.25mm layer height. Accidentally added a brim, but it's not needed.