Light Bar Wiring Conduit - Ender 3 V3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple alternative to drilling a hole in your rail
- Rating
- 5 / 5
- Likes
- 59
- Downloads
- 198
- Makes
- 3
- Views
- 2,252
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
The new Light Bar for the Ender 3 V3 SE is OK, except they leave you hanging on how to run the wires to the Motherboard. The instructions don't mention that you need to drill a ¼ inch hole in the top of your right Z-rail. Which if you screw up, would imply it's covered under warranty… NOT! Plus I didn't want to take off the gantry and risk misaligning something.
This alternative uses 1/8 inch Split Wire Loom (Amazon) and three printed parts. The clips all just snap-in… The hardest part of this install is getting the wire into the conduit; Cut a 2 foot (24 inch) length, you can trim later. And make sure it's split ahead of time. Use a butter knife or something to open the split and work the wire in a little at a time..
Update 12/21/23 - Added an STL for the Conduit Passthrough flipped 180 degrees; This will put the Supports where they are easy to remove vs. digging them out of the inner area with those delicate mounting tabs.